![]() ![]() When you are satisfied, you can then mount the off board components to the box and finish it up. I used shielded wires for the main signal paths so most of the time was spent cutting and preparing the wires.Īfter soldering all the parts, test and check that everything is in working order. I only have a hand drill at home so drilling the holes is a tiring and time consuming process for me.Īnother tiring and time consuming process is to connect the off board components to the PCB. I first gather all the parts and put them inside the box to visualize the spacing, make sure that they will not clash with each other before drilling the holes (which is a mistake I often made in the past when building guitar effects). ![]() ![]() This is reliable and cost effective, and I can also replace/ fix the mics easily in future if they are broken. The concept of this project is to make the toe-in/ toe-out angle adjustable, and the idea was to use the right angled plug coupled with the jacks, so I can set the angle while keeping the mics connected to the circuit. I have a metal box that I planned to use for making guitar effects. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |